DEI 508D MANUAL PDF

  • June 19, 2019

I’d like to hook up a DEI D Field Proximity Sensor to an Arduino. This is the “manual”: Manual or automatic transmission selection. Note: In the case of D, power and ground must be hardwired to the . DEI feature error. Protect your vehicle with an invisible sensing field which detects moving high- density objects (including people) near your car using Radio Frequency (RF) field.

Author: Samulmaran Fek
Country: Libya
Language: English (Spanish)
Genre: Education
Published (Last): 27 July 2007
Pages: 472
PDF File Size: 4.64 Mb
ePub File Size: 2.35 Mb
ISBN: 157-4-96030-655-6
Downloads: 84502
Price: Free* [*Free Regsitration Required]
Uploader: Didal

Open-collector or open-drain, same thing outputs are nice and flexible like this you can wire several of them together to one pull-up resistor to make a hard-wired AND gate too.

DEI D Field Proximity Sensor

How would I sense that, and is it OK to connect that dfi directly to the Arduino’s 5V power even though this runs on car 12V? If only the latter works and gives But I found good input to the initial problem under: Without a resistor, it measures 0V when inactive, about 6.

  DONDE TERMINA EL ARCOIRIS CECELIA AHERN PDF

When the alarm is triggered the signal pin is connected to ground. With a 10K resistor connected between the output and the 16V rail sorry, no 5V available right 508it reads 15V at the output when inactive, but drops to zero when triggered.

DEI Viper d Manual and Advice?

Now I’m starting to see what the term “pull-up resistor” actually means! Measure the output voltages with nothing connected, and then again with 10k resistor from output to 5V. It’s a 12V circuit, it has two outputs which I’d like to sense. Manial I first tried hooking this up to my Arduino I was worried about the sensor running on 12v.

However I’d suggest it would be deu to measure. If both generate an output then take note of the voltages involved.

I didn’t want to pass that voltage into the Arduino and fry it. Is there something I can read online to get a better understanding?

The blue wire is “alarm” – someone’s entered the smaller alarm perimeter. This is the “manual”: I know thread is old. That means it’s grounding, right?

  AUXILAB CATALOGO PDF

If 12V you’d need a level shifting circuit such as resistor divider. Eventually I realized that the signal pins are left floating when the alarm is not triggered. This means you can connect the signal pin to a Arduino digital input pin, but you need to connect it to a pull up resistor so you get a constant value. MarkT Brattain Member Posts: Thanks for your help!

DEI Viper 508d Manual and Advice?

Check the PDF Manual: Great, thanks so much for your help! Hmm, rather unclear that document and my neck now aches I think it might mean the outputs are open-collector capable of mA sink.

Mqnual took a few electronics courses back in college, but have forgotten most of it. I’m also trying to use this sensor, but confused about what the blue and green wires do.