When looking for a used DECKEL FP1 for sale, it is helpful to make sure that the instructions manual and operating instructions, the data sheet spec are also. New electical cabinet with emergencystop. Safety hood with electrical switch. Collets with sleeve S20x2 Drill chuck. Some toolholders and tooling. Add to cart.
New complete spiral milling facility with SK40 Werkzeugazfnahme. The upper stop, to limit the table’s vertical rise, was fitted with a micrometer adjustment. I am eager to see more Your contact seems to be inactive.
The first stage in scarping the front face of the column was to rough out front face of the column back to sound metal below the scores and area of corrosion. FP with maker’s countershaft drive.
Deckel FP1 Millers Page 2
I don’t fancy having my machine down for long so I have basically worked around it for now. Although purchased over two years ago the machine has been stored in the garage until I commenced devkel rebuild in September last year, although some preparatory work was undertaken earlier. Make sure you select the options which permit them to be visible to all. The following photos show further details of the initial condition of the column. This is clearly outside the tolerances specified by Connelly of 0.
Because only very small cutters, required to run at very high speeds, were employed, just two speeds of and rpm were provided. Check of the trade licence or commercial register extract. Hope this helps Sean Posted By: Like one of the newest, square FP1’s.
Sean S in SoCal Hmmm, well John, thanks for the FP1 manual downloads; I noticed the machine serial number hand-written on the cover dcekel “FP1 Parts” is Can you comfortably run a 2″ carbide insert cutter on tool steel with an FP1?
Could you cut-and-paste one of the BB Bulletin Board codes into a message, from one of those photos, so I can see what it looks like? Always a bad thing. The FP-2 is not much larger in footprint than the FP-1 and has the much appreciated function of powerfeeds in the y axis.
Login to Your Account. Good operational condition upon request under current demonstration ready.
General Layout Constructed in an ingenious way, the layout of the spindle-drive system was both compact and effective: Stan It does help. Langenlonsheim, Germany dealership location. So from here on you will use the front face of the column as a reference plane?
All gears, and their deckek, both spindle and table drive, were hardened and ground-finished. For one thing, the way you work on the Deckels is different Very good condition, from training. The bright side is However, unless one can find a suitably powerful and priced 2-speed single-phase unit, it would be far better decekl consider using a phase converter, and retaining the original electrics.
Be suspicious of any example that shows evidence of rounded nuts, hammer blows to any of the casings or other signs of brute-force intervention – it may have been through the hands of a mechanical incompetent and suffered hidden, serious and expensive-to-put-right damage.
Toolroom milling machine Deckel FP1
The results were impressive so much that until approximately 50, copies of the FP1 milling machine were sold. I will be sorry to see them go. FP-2’s should be worth less in my opinion, but ffp1 seems that the owners of them think they should be worth more because of the higher model increment.
Cover milling machine FP1 Maschnr. A shear pin, hidden under the rotating spring above the coolant pump, was fitted to protect the table-drive mechanism against overloading.
Machineseeker Trust Seal
The in-and-out movement was around mm. As I had yet to source replacement bearings and also I did not want to contaminate new bearings with cast iron fillings or should that be scrapings! You are chatting with: Deckels are being hoarded as they fall out of the machine shops that didn’t make decel, and I suspect they will dry up over the next few years and live happily in the home shop environment.