FFT10 interface or RS interface. For. For. EKC EKC For. For .. Danfoss can accept no responsibility for possible errors in catalogues, brochures . Introduction. Features. EKC (for panel mounting) and EKC EKC and are used for. • temperature Danfoss Pt sensors are supplied with . Danfoss EKC – Download as PDF File .pdf), Text File .txt) or read online.
The programme will for instance upload danfss the collected temperature values once a day. This input will register the position of a connected switch and depending on the functions you want to use, it will work, as follows: If the controller is provided with an alarm relay, it will also be activated.
Danfoss Pt sensors are supplied with the controller: Send This is not what you are looking for?
Danfoss Electronic Controller (EKC EKC ) –
The time delay is set in minutes. Push the lower button Set of a menu 1. A04 Door alarm delay Reset alarm The function resets all alarms when set in pos. Alarm relay not activated Room temp. Danfosss Member Since Here is a list of the messages that can appear: If a PTC sensor is used, the temperature will be shown in whole figures 1. E Here you can see how controllers are mounted and programmed.
Change Code Re-establish all factory settings Change Room temp. In the event of error function, the actual parameter code can be displayed.
Controller for temperature control – EKC and EKC Manual |
When the time for door alarm A04 expires, a failsafe function will enter into daanfoss compressor and fan will be star ted. During these 20 minutes the compressor will be star ted and stopped with this percentage setting.
A02 Lower deviation Temperature alarm delay If one of the two limit values is exceeded, a timer function will star t.
The controller will register when the DI input is cut in. Push the upper button until a parameter is shown 2. F02 Fan del comp out Fan stop at open door If you have selected the DI-input for monitoring a door switch, you may also stop the fan when the door is registered open.
If a module with data communication is mounted, the controller can send the status of the switch function to the data communication network.
Fan stopped at cut-out compressor Here you can select whether the fan is to be stopped when the compressor is cut dantoss F01 Fan stp comp out Delay of fan stop when compressor is cut out If you have chosen to stop the fan when the compressor is cut out, you can delay the fan stop when the compressor has stopped. Push one of the buttons and find the parameter you want to change 3.
The temperature at the defrost sensor is shown here. FZG series Square vacuum Dryer in feed industry dahfoss fish food.
Example on menu pictures Alarms If the controller is extended with data communication, it will be possible to define the importance of the transmitted alarms.
Here you simply set how often defrost is to be star ted. It is transmitted nowhere. Once receive your question, the supplier will answer you as soon as possible. The time when water drips off the evaporator.
Controller for temperature control – EKC 201 and EKC 301 Manual
If you have chosen stop based on time, this setting will be the defrost time. The digital ddanfoss can be programmed to – receive alarm signals from an external signal source door alarm – start defrost from an external clock danfos transmit random alarm signals to the bus system. Defrost sensor Here you can set whether a defrost sensor has been mounted.
The importance is defined with the setting: Factory setting If you need to return to the factory-set values, it can be done in this way: Three LEDs indicate the actual condition of the system: This gateway will now control the communication to and from the controllers.
The number of relays will then be increased by one. If SPST is cut in, defrost starts.
Danfoss Temperature Controller Electronic Controller Ekc 201
Shor tcircuited defrost sensor E5 Def. Shor tcircuited room sensor E3 Air sensor s. There are two kinds of error repor ts – either an alarm occurring during the daily operation, or a defect in the installation.