ICM datasheet, ICM pdf, ICM data sheet, datasheet, data sheet, pdf, Intersil, General Purpose Timer, Dual, CMOS. The ICM and ICM are CMOS RC timers providing significantly improved performance over the standard SE/NE/6 and timers. Details, datasheet, quote on part number: ICM The ICM and ICM are CMOS RC timers providing significantly improved performance over the.
They are not intended for use in Reflow solder processing applications. See Tech Brief for details.
Download the Sitronix ST7556 LCD Controller Datasheet
E and eA are measured with the leads constrained to be perpendicular to datum -C. RESET will dominate all dahasheet inputs: The circuits are triggered and reset on falling negative waveforms, and the output inverter can source or sink currents large enough to drive TTL loads, or provide minimal offsets to drive CMOS loads.
N is the maximum number of terminal positions. Applies only to military temperature range product M suffix. This avoids the multiple threshold problems sometimes encountered with slow falling edges in the bipolar devices.
Converted inch dimensions are not necessarily exact.
B1 maximum dimensions do not include dambar protrusions. In the one shot mode, the pulse width of each circuit is precisely controlled by one external resistor and capacitor.
All Rights Reserved All other trademarks mentioned are the property of their respective owners. Extremely Low Input Currents. Mold flash or protrusions shall not exceed 0. datasheett
ICM Datasheet(PDF) – Intersil Corporation
In this circuit, the frequency datashedt These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures. At a supply voltage of 4.
In case of conflict between English and Metric dimensions, the inch dimensions control. These parameters are based upon characterization data and are not tested. This provides the possibility of oscillation dataasheet modulation in the astable mode or even inhibition of oscillation, depending on the applied voltage. Timing from Microseconds through Hours?
At all supply voltages it represents an extremely high input impedance. Specifically, the ICM and ICM are stable controllers capable of producing accurate time delays or frequencies. The chamfer on the body is optional. Trip points and output swings are symmetrical. Terminal numbers are shown for reference only.
This is a stress only rating and operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
Interlead flash and protrusions shall not exceed 0. If it is not present, a visual index feature must be located within the crosshatched area. This functional diagram reduces the circuitry down to its simplest equivalent components. As such, if driving CMOS, the output swing datasheeet all supply voltages will equal the supply voltage.
Dambar protrusions shall not exceed 0.
For this reason it is recommended that no inputs from external sources not operating from the same power supply be applied to datasyeet device before its power supply is established.
D, D1, and E1 dimensions do not include mold flash or protrusions. For astable operation as an oscillator, the free running frequency and 75556 duty cycle are both accurately controlled by two external resistors and one capacitor. Tie down unused inputs. Guaranteed Supply Voltage Range. The timer can also be connected as shown in Figure 2B. Mold flash, protrusion and gate burrs shall not exceed 0. Operates in Both Astable and Monostable Modes?
Initially the external capacitor C is held discharged by a transistor inside the timer.