3com SuperStack 3 T Pdf User Manuals. View online or download 3com SuperStack 3 T Getting Started Manual, Datasheet. User manual for the device 3Com SUPERSTACK T. Online user manual database. Get 3Com SUPERSTACK T Switch User Manual. Get all 3Com manuals!.
3Com SUPERSTACK T user manual – – Solve your problem
It manuzl the following topics: Setting 426t Web Interface Management This software allows you to communicatewith the Switch via the console port directly, or through a modem. Setting Up Snmp Management If connecting a modem to the console port of the Switch Series, only use a modem which is suitable for connection to the telecommunications system. Full Screen Viewing – to easily view the user manual without downloading it to your computeryou can use full-screen viewing mode.
Make a note of the Network IP Address. If your IP network is internal to your organization only, that is, you do not access the Internet, you may use any arbitrary IP address as long as it is not being used by another device on your network. Page 2 Environmental Statement It is a 3Com policy to be environmentally friendly in all operations.
Thewhole setup process is summarised in Figure 8.
3Com SuperStack 3 4226T Manuals
The whole setup process is summarised in are contained in the sections that follow. However, to make full use of the features offered by the Switch, and to change and monitor the way it works, you have to access the management software that resides on the Switch.
Package Contents Water or moisture cannot enter the case of the Switch. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in 4226t commercial environment. See 3Com recommends that you use Category 5 twisted pair cable — the maximum segment length for this type of cable is m ft.
Switch Family – Rear View Detail If yourproduct is registered and under warranty, you can obtain an RMAnumber online at http: The final page displays a summary of the information entered. Warnings contain directions that you must follow for your personal safety. Connecting A Redundant Power System If installing the Switch Series unit in a stack withSuperStack II or SuperStack 3 units that are narrower than the Series, the Switch Series unit must be installed below the narrowerunits.
The topics covered are: These are shielded RJ 4226f sockets.
Approved Gbic Transceivers Installing The Switch You must do this whilst the Switch is offline, that is, before you connect the Switch to a network.
Follow all directions carefully.
Switch Family 1 Plug the power cord into the power socket at the rear of the Switch. SC connector on the transceiver. About The Switch Family Summary of the content on the page No. The Switch has identified that the GBIC does not meet the minimum requirements for the Switch and has disabled the port.
Solving Hardware Problems maanual Redundant Power To protect against internal power supply failure, you can use this socket System Soc. Many ports on workstations andservers are configured as MDI straight-through.
3Com 4226T – SuperStack 3 Switch Manuals
About The Switch Family Family consists of: These featuresare enabled on a browser by default. The Switch has three manusl user names, and each user name has a different password and level of access.
This manual is printed on paper that comes from sustainable, managed European forests. However, to make full use ofthe features offered by the Switch, and to change and monitor the way itworks, you have to access the management software that resides on theSwitch.
Passwords command line interface, or to change the default passwords, you need to log in with a valid user name and password. Redundant Power To protect against internal power supply failure, you can use this socket Setting Up Web Interface Management If the login prompt does not display immediately, press Return a few times until it starts.
Important Safety Information This is known as managing the Switch.